MicroSquirt.com read only forum (Jan.15,2018)

I am using MS-II with a 3.0 board,and 2.36Megatune with a wide band sensor
Has any one seen at the bottom of the screen while in the auto tune mode, It say out of window?
Thanks
Scott

Hi Lance
You were a great help! I thought that I had the latest version of embeded code. I was wrong. I had 2.3 I does idle down now. We are making headway! Thank you again.
P.S. We just bought a wide band sensor and accesories. That should put the iceing on the cake!
Scott

Hi
What is the latest .s19 file that will support ford EDIS and where is the best site to get it?
Scott Bruce

Hi In running MSII witha ver 3.0 board I think ( the unit was purchased assembled) and using 2.25+ megatune
Has any one come up with a fix for the engine not coming off high idle after warm up? after warm up, I have to restart the engine and some times that even won't make it idle down. I asked this ...

hi

are you saying the latest code for the idle control or both of the problems
Thanks
Scott

So your saying to set megatune to wide band sensor instead of narrow band in the EGO settings?

Another question, has any one found a fix for the idle air control so that the car will idle down after a cold start with out having to restart the car?It never start, warms up and idles down with out a ...

Hi Lance
I'm using a MS-II with I believe version 3.0 software. Isn't the o2 gauge suposed to go up to .9- 1 volt when you put your self in series with the sensor input wire and 12V pos? It only goes to .4 volts. ( I was taught to use a 1.5 volt battery or put your self in the circuit). I get cross ...

I'm not sure of the firmware. My brother installed it. It was installed about 2 months ago and i believe it was the latest at that time.
Scott

Hi
I have a strange problem. On initial start up, the IAC valve does not close at the 160 deg water temp. Upon re start, it will idle down. Seems strange. Has any one seen this problem?
Scott Bruce 69 Turbo Lotus Europa

Can any one tell me how many steps the niehoff IAC part number 21774 motor has? At 300, and the block that was purchased from DIY auto, will not seal. I went to 320 and got a message that the setting had to be 300. Please advise.
Scottt Bruce