MicroSquirt.com read only forum (Jan.15,2018)

I see now. Thanxx a lot

MS II V3 Mt 2.5 My question is if i should ground the braided part of my ignition signal wire. This is the shielded type of wire and has a layer of braiding to it (looks like an antenna wire). I ask because i opened my relay board to ecu connector from DIY Autotune and noticed that the wire is ...

well that thing only corrects the signal to use it with a tac if yours doesn't work i know the MS II has that built into it.i dunno if you're triying to control your spark but or just correct for a tac What you triying to do anyways??

When you talk about btdc or atdc you talking about advance. That means +20 BTDC the spark is bein produced 20 crankshaft degrees before the piston reaches top dead center so the piston is on it's way upp when the fuel is ignited. This is nesesary because the fuel takes some time to fully ignite. If ...

ok is there a relay for the fidle circuit on the relay board?and if there is can i use it for the ing setupp or it would be easier just to add a separate relay.But i have another problem now thanxx to >>Lance<< i saw that i can use MS II to control my torque converter clutch wich i really need with ...

i'm working on the wiring for my MS II and i'm gonna be using a relay board with it and a relay board to MS II cable from DIY Autotune. Now i was searching the megamanual for wiring a 7 pin hei and the picture shows pin E going to db37 pin #36, pin R to db37 pin #24 and a connection from a relay to ...

i don't think it should be a problem having them vertically,most of the vehicles do anyways. But angled to the valve would be ideal.if you want to have them angled then you can take the manifold to a machine shop and have them add some material to were the bung is gonna be mounted then drill the ...

msII v3 2.5 small block chevy ok i need info on how to wire up my fuel injectors(they are 12 ohms or hight imp) to the relay box. my biggest question is if i should wire upp one bank to each inj wire or if i have to match upp the injectors that are firing at the same time if any of you have a ...

thanx a lot to all of you guys that's one less thing i have to worry about i'll go with the 7 pin setupp

using that setupp u just mentioned will i stoll be able to control my timing ; also i built the MSII with the gm 7 pin in mind so i'm using the jumpers for a hall setupp