MicroSquirt.com read only forum (Jan.15,2018)

have you tried checking the headlight fluid?

I have a similar question about that. Can I tune each cylinder individually? Or is that something thats done through the software?


Blown-imp... Why not just get a larger set of injectors. i just talked to a guy on ebay that is willing to sell anywheres from 72lb - 150lb bosch style injectors for ...

I have the same injectors... (orange bosch) I believe the pressure regulator is set at a pretty standard 43.5lbs. that's about 22 lbs per hour.

Ok so i really can do it either way. Since ms2 has the higher resolution I won't have to worry about dribble or poor idle....I think I got it. Thanx lance your the MAN!!!

ok I've been reading some other treads... If I set up 2 injector banks... using the 240cc injectors up to an 80% duty cycle, can I then setup the larger injectors to start firing when boost is appied? Can msII apply more fuel according to boost? Since I'm using a maf instead of a map, will I have to ...

I'm putting efi on my yamaha banshee (400cc - 2 cyl - 2stroke)... I have 38mm TB's off a gsxr 600 '02... They came with 240cc injectors which is just enough to run the motor like it is. (that would be about 90% duty cycle) BUT, I'm going to be putting about 30lbs of boost into it after I get it ...

I'm not so worried about it. I have seen a stock banshee w/20psi. I've gone to great lenghts to prepare my motor. As far as the center seal it's not the oem rubber one. it's been redesigned with an alum body w/ triple o-rings. And since the turbo will be pushing in air throught the reeds equally on ...

I've been reading as much as i can about set up and wiring... megatune manual and bunchs of info on anything I think I need to know. Starting from square 1, like everyone here has. It's hard to know where to start with the sheer mass of info on this site. So i put it to you smart guys to help me out ...

Yeah, now were talkin' I'm trying to be patient but I feel like a kid on christmas eve. Turbo Banshee awaits!!!! Keep up the great work guys. We are all behind ya.

Hey thanx again!!! I'll be sure to get back to you on that. Only need a micro and I'm off to the races... after some time on my bro's chassis dyno. Land & Sea baby!!! http://www.baldturbofreak.com