MicroSquirt.com read only forum (Jan.15,2018)

alright guys, been workin on it pretty much non stop, here is where I'm at:

the msd sparks when pin 36 is grounded-working properly
the MS when 12 is applied registers rpm and the pulsewidth is still not moving, not too sure why - is this normal? but other than that seems to be working, tried ...

well tried to spin the dizzy by hand and nothing came out the pip, then checked for 12v at the tfi, the one that has 12v run and start is present, the other, start only had nothing, so I ran a wire from the started solenoid to that one, still nothing, this is on a 95 mustang with the remote tfi ...

the rest, ok, this is where I'm at right now,

the hall circuit is installed as per megamanual, the mods on the tfi specific site are done

V3.0 board
We will use the opto input so none of the VR components are actually required, they do not hurt if you have already fitted them though.
Jumper ...

the instructions on the msns-e site for tfi it says 'only for driving coil from the tfi module, then it has the drawing for the led 17 circuit below that

I have no 330 ohm resistor, and the mods on the input, I removed d1, and installed a jumper, and put a 1k 1/4w into d2, is there something I'm missing here?, I went and looked and my pip to the shielded pin 24 was touching the metal shielding, chenged that and still nothing at all

when I hooked up the led 17 circuit, I simply put a wire from the neg side of the led, and went to pin 36 on the db37. the input is tapped into the pip on hte tfi. now if the pip wire is touching hte shielding at all, will this cause me some problems?

would I still see the cranking boxcome on even if it wasn't getting a good signal through pin 24?

would having dwell time @ 1.0 ms not be a long enough to make the msd n ot see a signal?

I'm going to check that out right now, if that doesn't work, do you think I would need to add the pull up circuit? I tried the stim on the MS and everything worked so I'm not too sure whats going on with it.

sorry, this is the msns-e MS1 also on a mustang gt

hello everyone, here are the problems I'm having right now

the car will not start, getting fuel, but no spark
the crane hi-6r I'm running has a status led that says - power supply fault on initial startup
the screen when ignition on and starting shows rpm and pulsewidth to be 0, both stay pink ...