MicroSquirt.com read only forum (Jan.15,2018)

I am using the following setup

Microsquirt Ver 2.88
Edis Ignition
4AGE - No idle control system

How can I use microsquirt to control a cooling fan

Thanks

I sent you an email.

I tried to reflash and I am now getting this message

MegaSquirt Download 1.04

Reading C:\Program Files\MegaSquirt\Firmware\MS-II\Monitor_v2.883j.abs.s19:
C:\Program Files\Metrowerks\CodeWarrior CW12_V3.1\MSIIC_Proj\bin\Monitor.abs
Detected MS-II (HCS12) code.
Entry point: 0x0000
Code range ...

So, you were able to download your MSQ after a bootload or not?



Yes I am recycling the power .
I tried and I even disconnected the battery at times.


When i try to set the ecu to 2 in the general menu i am unable to write the changes to the controller.

It seems in in a bootloader loop. ????

I tried connecting the bootload to vref and I am still unable to connect to microsquirt.

It seems I am stuck in bootloader mode

I tried using port checker to find microsquirt and it did not find the microsquirt. However I notice that I am able to flash the microsquirt with or without the jumper connected . (strange)

I tried flashing it with and without the bootloader jumpered and it reported that 4 files skipped and 1429 ...

I am having a similiar problem.

I tried using port checker to find microsquirt and it did not find the microsquirt. However I notice that I am able to flash the microsquirt with or without the jumper connected . (strange)

I tried flashing it with and without the bootloader jumpered and it reported ...

I tried using port checker to find microsquirt and it did not find the microsquirt. However I notice that I am able to flash the microsquirt with or without the jumper connected . (strange)

I tried flashing it with and without the bootloader jumpered and it reported that 4 files skipped and 1429 ...

I re-flashed the ecu with code 2.88 and the TPS started to operate correctly . Then I reloaded my msq file and the controller lost connection with the laptop. I tried reflashing the ecu and it was successful but I still can't connect to microsquirt with megatune.


So I can connect to the ...

I re-flashed the ecu with code 2.88 and the TPS started to operate correctly . Then I reloaded my msq file and the controller lost connection with the laptop. I tried reflashing the ecu and it was successful but I still can't connect to microsquirt with megatune.


So I can connect to the controller ...