MicroSquirt.com read only forum (Jan.15,2018)

Yes and most likely yes see this thread http://www.microsquirt.com/viewtopic.php?f=31&t=23243 I hope this helps

here is a msq for the GPz 900R running uSwith 2.89 code

When you say you have resets - is this processor resets or ignition resets? The opto input is totally isolated from the rest of the microsquirt circuit, so if you are getting processor resets then I suspect there is something else going on...

You can tell a processor reset because the time ...

Bruce I tried the setup you suggested (Optoin+ to neg coil and Optoin- to +bat through a 4.7K resistor) and the unit suffered serious rests and was undrivable so far the best setup is my original Optoin+ to neg coil through a 10K resistor and Optoin- to chassis ground. it still has occasional resets ...

Bruce I tried this and the unit suffered serious rests and was undrivable so far the best setup is my original Optoin+ to neg coil through a 10K resistor and Optoin- to chassis ground. it still has occasional resets but they usually donteven activate wue or ase. is there another setup you would like ...

heres some more info on tb's and injectors that I could not find anywhere. I used the formula and injector test mode in uS to get these values
Make/Model: ZX6R
Year: 2007
Number of Tb: 2
Inside Diameter: 38mm
Center-Center (left to right from behind):
Overall Length: 90mm
Outside Diameter ...

sounds exactly like this http://www.microsquirt.com/viewtopic.php?f=87&t=23033&hilit=bike+died+on+the+dyno

And I think I may be working on a simalar problem with mine here http://www.microsquirt.com/viewtopic.php?f=31&t=23243
Bruce is working with me now on this and hopefully it will be sorted ...

just for future reference heres the circut Ive been using to trigger uS. This worked until the resistor broke and I tried to run without it to get home. so it looks like the opto circut (R20) can be damaged with out a resistor.

Brookster wrote: Cheers i'm no expert on a Laptop , do i do this in the device manager ?

each of your USB ports has a number while watching in device manager change ports until you find one with a lowenough number.
cheers,
Matt

I tested R20 and got a couple of values on the >+ setting the value was 1460 ohms, and the 20K setting was 2.32 so 2320? heres some pics any ideas? could I go to rad shack and get a new resistor of the value 680 ohm @1/4watt and replace?