MicroSquirt.com read only forum (Jan.15,2018)

Thank you so much for the information so far! OK so I will get a 1/8th watt 2 or 3 K ohm resistor to use in line with the Vref. Then, I suppose because I am using a bias resistor I will have to redo the temperature measurements again measuring between ground and the line going to the ECU pin.

I should mention that I am using a Microsquirt V2 module. Can the V2 use the two wire setup as you described with out connecting to Vref?

The link you supplied that explains the setup does not give a suggested value for the resistor that limits the current to the module (R sub p).

What size resistor goes in line with the Vref (Ohms and watts). I have taken my multi-meter and recorded resistance values for each of the sensors at ice-water (32 deg F), boiling water (212 deg F), and ambient air temp. Do I have to do this over again? If so, what is the setup?.... Connect to Vref ...

Hello,
I custom made my own 10 Kohm NTC temperature sensors because of where they had to go in my application. I wanted a very small sensor tip for my air intake sensor so going with GM style sensors was not going to work. Here is my question:

If the actual thermister has only two leads because it ...

I relocated the wireless router so I could have internet while plugged into the bike. It worked like a charm. Tuner Studio asked me if I wanted to download the correct .ini file and I said yes. Thank you for the tip!

My garage may be out of wireless range from the house. I had not checked to see if my laptop had a signal. I can relocate the wireless router to get a better signal. I will try that tonight.

Hello,
I am trying to set up a 1983 Honda CB1100F with a Microsquirt V2. I bought the Microsquirt in 2010. Life got in the way and I have only been able to install the fuel injection system this month. I have communication between the laptop and the Microsquirt. I am having issues with finding the ...

I am using this as a fuel only for a 1983 Honda CB1100F four cylinder motorcycle. I have the toothed wheel and sensor for final configuration but I wanted to get things working with the Dyna 2000 Ignition system that I have on it now.

Are you sure about the single signal for every revolution?
http ...

What size diodes do I use with this setup?

I am using a NTC thermistor 10kohm I bought from digikey. Do I have to be worried about overloading the thermistor? It has a max power rating and I cannot find any specifications on pin 25 and pin 26 for my Microsquirt.