MicroSquirt.com read only forum (Jan.15,2018)

what unit would i use for an odd fire v twin, i need to retard timing from a switch as an antilag, i need to retard timing under boost and i need a rev limiter

Matt Cramer wrote:27 is not any better when the correct value for Skip Teeth needs to be 36.

i'm sorry to bother you but i want to understand.right now #1 cylinder tdc is five teeth past the missing tooth so i have a delay of four teeth.do i remove delay teeth and skip teeth???

i,m sorry i wrote the info wrong-delay teeth four,skip teeth 27

Matt Cramer wrote:Delay teeth must be set at 36, as if this is an even fire engine. You then use the offset angle to specify the #2 cylinder timing. Setting delay teeth to 28 is going to confuse the wheel decoder.

i,m sorry i wrote the info wrong-delay teeth four,skip teeth 27

45 degree odd fire harley-36-1 trigger wheel-setting trigger wheel teeth at 37-i missing tooth-skip teeth four which puts me at tdc front cylinder-after 405 degree crankshaft rotation-delay teeth 28-offset -315 the only way i get the front cylinder to spark is when cranking speed almost stops,then ...

megasquirt201006041639.msqturbo1.msq2.msq

please review this file it is a 45 degree harley turbo,odd fire,300 lb injectors on ethanol afr 6.5,right now my ignition timing is off it will barely run it;s so rich it throws fuel out the exhaust-please advise if possible

i have a microsquirt with the 2.89 code when i bring a tune file up in tuner studio i get a message that it is not a 2.25 file how do i run my 2.89 code in tuner studio???

i am running a fourty five degree odd fire harley,single crank trigger wheel 36-1 teeth,currently i have skip tooth followed by tdc cylinder #1 four teeth later,cylinder #two tdc six teeh later question A:where do i set spark delay right now it is set at 35 degrees i have set cylinder #two at 325 ...

yes i did how do ii fix it?????

i loaded code 2.89 to a microsquirt now i have no real time screen it is all zero,also if i try loading a map it tell's me my voltage is to low???what did i do???