MicroSquirt.com read only forum (Jan.15,2018)

Oh yes. The MSQ. You may need that.

OK I couldn't Wait. I set up the single VR. It worked great. Almost brought tears to me eyes to here that thing run like that. Still allot of tuning to do but I do have 2 data logs for you. Please by all means, if you see anything I need to change in the settings, let me know. But for now thanks ...

OK I will set up a crank VR with 1 flag for now. I will do it this week end. Please, keep an eye out for me on Monday. I will give you a full report and hopefully a data log. Thanks

OK I think you mean from 1 of the 2 coils. Yes. OK I did that and changed from 2 cylinders to 1. But it said 2 squirts was no good. Something about PWM being to small. So I changed it to 1 squirt. Then it said alternating wouldn't work so I changed that to Simultaneous. I started the bike and it ...

OK first. The pulses are uneven. 0 deg, 315 deg and then 405 deg (0=720 deg total) Typ for Harley with 45 deg cylinder offset. It is a it is normally a 10V high with 0 v pulses. I have checked it with an Oscope at the input to the CPU at pin#1 it is a strong signal ( I can see the rpm on mega tune ...

Hi Matt:
Thanks for responding. I had given up hope that anyone would. I sent the MSQ as requested and a new data log. I am getting my pulses from an ignition module, and in case you need to know anything else, let me run down the list of STUFF. The ignition module is a Daytona Twin Tec model 1005 ...

Thanks you for responding Matt
It's getting the signal from an ignition module primarily but I have tried both. In any case my signal is a 10 Vdc square wave. I have OScoped it to pin# 1 of the CPU it is clean there at 5Vdc Square. The problem is in the CPU. Hopefully I have something set wrong in ...

Hello everyone. I am a bit perplexed with my input results. I am running a MicroSquirt unit(Black Board) version V2 with 2.89 code. I was originally using it for both Ignition and Injection but because of the configuration of the motor, a V2-45degree with no tooth wheel, I found it simpler to use ...

Hello everyone. I am a bit perplexed with my input results. I am running a MicroSquirt unit(Black Board) version V2 with 2.89 code. I was originally using it for both Ignition and Injection
but because of the configuration of the motor, a V2-45degree with no tooth wheel, I found it simpler to use ...