MicroSquirt.com read only forum (Jan.15,2018)

Thanks will give that a try.

Two Questions,

1) When using Duel tables, can you set up each table with differant kpa/rpm values?

2) Will Analyzer live correct both tables at the same time?


Thanks

George

here is log file

Been working at this for a week, hard pull from 2k rpm in 2nd, and motor is rich (10:1), shift to 3ed and motor go's lean, all this is in the same fuel map bins. msq attached, log will be in next post. injectors are 65lbs/hr low Z (2.5 ohms).

After conversation with Matt at DIY, found R20 open on board, replaced, car now running on uS. awaiting custom made twin injector Throttle body.

Iput on opto + is 0-8v, 0v when points closed, 8v when cranking points open, I should think this is enought to drive uS. Set up ing to run off MSD, all sensors reading good, hooked up ING1 to new coil -, put 12v on coil +, added wire from coil to sparkplug, grounded plug. With car running off MSD ...

Update--using o-scope have good sig from points to uS, on INGOUT I have a 5vdc pp pulse riding on a 5vref. so 5v to 10v pulse. I beleave it needs to go to 0v to charge coil. Is this a setting or is something bad?

Am trying to run MSD box from microsquirt, get good tack when reading off coil, but when set up to trigger off the points, get no INGOUT sig to fire coil. Coil is good, points good. Points are attached to 12 thru a 1k resistor. Opto + to points, Opto - to ground. Thing work great when just using the ...