MicroSquirt.com read only forum (Jan.15,2018)

Thanks a lot for your help I'll post in another section to see how to wire it in. Thanks again

ok so i jumped on your site and downloaded the lastest firmware (im not on my tuning laptop ) so i downloaded that and TS loaded firmware 1.1.1 and it has everything im needing like air shifting settings and anti-lag all the goods now what im needing to know if i load 1.1.1 on my tuning laptop and ...

how and where do i get a firmware with launch control?? thanks for the help

ok is it somthing TS has ?? im running a microsquirt v3 i really need this launch control to get the bike out of the hole thanks.

heres what i got

81 yamaha xj650 stock engine
turbo kit i built running 9psi
gm coolant temp sensor
gm air temp sensor
gm 3 bar map sensor
microsquirt

this bike has been running for about 7months without really any problems but im trying to find out how to fix my rich spot on interstate see ...

do you have rpm when cranking engine over ? whats this on setup details would help also.

quick run down of the bike
82 yamaha XJ650 stock engine 9:1:1 comp
home built turbo kit on 9psi
microsquirt
quadspark
420a neon coil
3 bar map sensor
gm iat and coolant temp
36-1 trigger wheel with one stock vr sensor
03 gsxr 750 throttle bodies with 240cc injectors
http://i114.photobucket ...

Did the resistor and no go well I thought I would try adjusting the air gap and that ended up being the problem thanks for your help

So just grab a 5k or 10k resister and put it on the + and - wire right ? I read somewhere of doing this

only reason the rpms drop out are caused by the fuel cut if i was to just hold it there lite throttle i could lightly bounce it there but i just cracked it wot.