MicroSquirt.com read only forum (Jan.15,2018)

which input do you wire the Dyna tach output into?

I'm running the version 2 (or I was) I have spent the best part of 2 years struggling with this so I have taken off the MS and fitted a Dyna ignition system just so I can enjoy riding the bike through summer again as I was not enjoying working on it any more. So I have 2 options now, either fit the ...

Just looking through the manuals again and came across the mod to change from coil driver to logic level output however the photo's don't appear for some reason. Does anyone have a link or a photo of where to physically put the jumper wires? I'm running the 2.x.x firmware.
Thanks.

Well its been a month of high's and low's. I managed to get out when the sun came out and lo and behold she ran perfectly, revving right up to 12250rpm clean as a whistle, so it turns out that my trigger wheel teeth weren't a good match to VR sensor size wise, also my new trigger wheel has only 24/2 ...

Hi crusty.
I too have a 950 adventure and am planning on injecting it sometime, however I am currently running a Microsquirt on my zxr750L which is now running well. I actually switched from a 36/1 trigger wheel to a24/2 (standard zx9r wheel) and it works a charm so you should have no problem with ...

A bit quiet round here these days, anyway I've had a few developments which may help someone. I carefully measured the teeth on my trigger wheel
and compared that to the pick up and found that there was a fair difference in sizing so I bought a trigger wheel from a ZX9R C1 which is a perfect match ...

24c Your right I was getting a bit pissed :oops: but I opened the throttle fully to try and get the crank spinning at a constant speed and therefore synch quickly so I could see what the other parameters were doing. Matt I get an almighty back fire now and again through the exhaust which I thought ...

Well I seem to be back at square one. I cant get the motor to fire I did a datalog while cranking and the dwell is going absolutely nuts, could someone please take a look and see what you think.
Thanks.

Hi guys.
Been a while since I've been on here due to various factors, mainly 4 cracked pistons! Due to me completely cocking up my trigger offset. So I thought if I'm replacing pistons I may as well put in big ones so it's now a 950cc :D
during the build I have been doing a bit of reading andi have ...

Hi
My laptop is kaput and I have lost all my info on the hard drive I have tried downloading Tuner studio (registered version) but it keeps asking for a product code which I don't have, any ideas?
thanks
Kevin