MicroSquirt.com read only forum (Jan.15,2018)

Hi
After successfully installing and setting up the Microsquirt system to my V6 Duratec, I have decided to upgrade the engine to a reasonable moderate Supercharger system plus water/methanol injection which will only kick in on WOT.
My question to the boffins is: What effect will this will have on ...

Hi
Anyone on here tried the Android version, I have downloaded the software from the site but have not tried it out yet, but it looks completely different to what is on a laptop?

Hi
Thought it may be better to have the tuning software on a Android Tablet instead of a laptop, however I downloaded the programme for a Android and all it shows me is a Dashboard and says "demo version" but nothing else to operate fuel tables etc. I have not connected to the car as I am in the ...

Hi

Double checked and all OK, have tested the SAW from ECU and have 2.5 volts @ idle and 4.4 volts @ 3000rmp tested @ EDIS module, so I'm assuming the EDIS is not seeing the voltage generated from MS, all settings are per MS manual for controlling an EDIS system

Alan

Hi
It would appear I have no ignition advance, stuck at 10deg double checked everything, I have no way of checking the pulse at PIP, would it be wrong to assume that the EDIS module is not generating a PIP? or can the Microsquirt V3 not generate the SAW back to the EDIS? on the laptop all is OK I ...

Update on this, bit of head scratching went on here, with no help from the www I decided to try the trial or error method, for anyone with the same problem as I had, use pin 2 on the EDIS used for diagnostics on the original Ford set up, but only works with modern electronic rev counters as I am ...

Running a V3 microsquirt system on my V6 Duratec, everything is fine and runs very well however I have only one nagging issue and that is the rev counter, I am using the original Ford Mondeo V6 rev counter and all was well at first except when any electrical functions was used the rev counter would ...

Hi
See if this works
Alan

Sorry file to big it says

I have an error coming up on my Tuner Studio when I select the sensor calibration tab in Tools, the error says:

Error Showing Dialog
for input string ""\000""

Any help would be appreciated