MicroSquirt.com read only forum (Jan.15,2018)

ok I understand, I am not sure if I burnt it I think I did, but never the less I do not think I did uS power cycle between settings change. I will try again and update you, thank for the help.

Here is my MSQ

I am running code 2.883 and I am trying to use the fidle pin as a fan controller. I have the idle control set at none and when I go to the spare output settings and enable the filde pin and set collant > 20 with hysteresis of 10, power on value of 0, trigger value of 1 the fan does not turn on, I ...

That was it. thanks for the great help

thanks for the great info. I will try tonight after work.

Hello,
I am trying to get uS to start a Honda CBR 600. I have not been able to get it started. I have two questions.
question 1
what setting is it that changes the cranking advance?

question 2
when I got o basic ignition setting and set trigger offset(deg) to 13deg I get the output below. the ...

Bad Module, Just use some HEXFETs instead.

I do have the setting set a going low. I have also hook an oscilloscope up and I do not get any positive pulses, if I simple unplug the inputs to the Bosch module I do get positive pulses.

SQLGUY wrote:so, as soon as you plug in the module, the outputs get pulled from 5V to 0V. Is that correct?

Yes that is exactly what happends. I have not check the resistance, what should it be?

No I left the internals if uS alone and I am using the pull up resistors all of the time. the only thing I change is if the module is plugged in or not.