MicroSquirt.com read only forum (Jan.15,2018)

Eric !

Now with fresh batteries everything works fine. Will no go on to install it in the case, and thereafter the car.

Thanks again !
/Patriq

Eric !

Thanks ! I forgot to mention last time, but I have installed the latest stable MegaTune.

Regarding pin 9 on the DB9, I was more worried about if x10 that is connected to the processor possibly was creating problems for the processor.
I have now moved this jumper to the hole next to the hole ...

I've jumpered x10 to pin 9 on the DB9 to feed it +5V for Bluetooth communication later on.
Could this be the reason why it doesn't communicate as it should? Should I have fed pin 9 on the DB9 with +5V from another source ?

Kind regards,
/Patriq

It's 2.25b749beta. The error message is: "ERROR:megatune.ini:0028 - The included file 'MegaSquirt-II.ini' could not be opened. MegaTune is terminating." Patriq,

Did you do the "File -> Activate" step while in the configurator? You need to click on the megasquirt-II.ini.n.nn file that contains the ...

Hi !

I've just installed MS-II card on my v2.2-board. But when trying to run MegaTune I get an error when starting MegaTune.
It's 2.25b749beta. The error message is: "ERROR:megatune.ini:0028 - The included file 'MegaSquirt-II.ini' could not be opened. MegaTune is terminating."

I've configured ...

Thanks !

You can read more on them at http://www.zagato-cars.com
They are extremely nice. Aluminium chassie, discbrakes all over, low wheight. Resonably stiff and low drag.

Oh.. I thought it was later "down there" ?

Regards,

The one in the avatar, or the one I'm squirting ?

The avatar is my Alfa Romeo Junior Zagato. I think they built 450 of them. Mine is a 1970.
The one I'm squirting is a Alfa Romeo 33 Q4 Sportswagon - 1993. It's got a 1.7 16V boxer engine. Same engine as in the Formula Boxer series.
I also have a ...

Hi !

Thanks - that was helpful !

I think I'll try without IAC then. And go for MAP after all.
(I've only soldered the board so far - and am setting up all sensors etc. within a week or two.)

Regards,
/Patriq

Hi !

Thanks for the answer. I've been thinking the same way as you - with dampers. But using these small ports will outrule using IAC - since I'm using the only ports available for IAC. Meaning I can't control warm up idle.

and....

I'm still wondering about how the extra air that comes into the ...

I'm about to install MS in a car that has ITB originally. Each TB has a small port where a hose from the IAC comes in. These ports enters under the flapper in the TB.

I've concluded that I won't be using these ports for MAP. Experiences from other with the same engine and MS says the vaccum signal ...