Search found 3 matches
- Mon Jan 10, 2011 6:04 pm
- Forum: Ignition Setup, Tuning, and Troubleshooting
- Topic: Using a stator output as a crank wheel
- Replies: 2
- Views: 734
Re: Using a stator output as a crank wheel
Awesome thanks for the information grippo. The stator rising edge does not change throughout the RPM range. The rising edge of the single tooth currently is a few degrees ahead of TDC but I guess that I can adjust the tooth offset so that the ECU knows were TDC is. I have also attached a closeup of ...
- Sun Jan 09, 2011 8:48 pm
- Forum: Ignition Setup, Tuning, and Troubleshooting
- Topic: Using a stator output as a crank wheel
- Replies: 2
- Views: 734
Using a stator output as a crank wheel
Hello, I'm in the planning process of squirting a single cylinder ATV engine. Today I hooked my scope up to the factory crank signal pickup which is a single tooth and the falling edge of the tooth is TDC. I also hooked my scope up to one of the stator output wires and found that it makes some what ...
- Sat May 02, 2009 6:47 pm
- Forum: Ignition Setup, Tuning, and Troubleshooting
- Topic: Single Tooth pickup
- Replies: 3
- Views: 720
Single Tooth pickup
I am looking to squirt a few atvs and would like to do both fuel and spark control with the microsquirt. Problem is that to make a 36-1 wheel work would prolly run a extra $200 in machine work and that makes spark hard to justify. The bikes I want to squirt all have a single tooth pickup that is ...