I was getting ready to play with the Accel Wizard and I have literally no noise from the TPS signal as indicated by the "Tell Tale" slider bar. The TPS has been calibrated and I get an ADC count of 52 closed and 940 WOT. Yet, when I look at the slider bar in the Accel Wizard and I stab the throttle very rapidly I get very little resolution as indicated by the red bar. It goes to about 15.
Is this normal? If it needs less resolution time do I just jack the TPS Averaging Lag Factor number up higher?
It is at the default of 50 right now.
Thanx,
Bud
No Noise But Little Resolution--TPS Signal
Forum rules
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
69 1/2 Six Pack Bee
- Helpful Squirter
- Posts: 74
- Joined: Fri Aug 20, 2004 10:12 am
- Location: Ontario, CA
I see the same problem, I think it's part of the same behaviour: http://www.msefi.com/viewtopic.php?t=16940&highlight=
I believe that slider is displaying tpsdot. I find I can get that meter to move furtherest when I let up on the throttle quickly - that can't be correct.
I believe that slider is displaying tpsdot. I find I can get that meter to move furtherest when I let up on the throttle quickly - that can't be correct.