AFR targets

For discussing MicroSquirt (TM) configuration and tuning of fuel parameters (including idle valves, etc.).
Forum rules
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
Speedbuster
MegaSquirt Newbie
Posts: 3
Joined: Sun Dec 25, 2005 9:16 am

AFR targets

Post by Speedbuster »

Hi people,
I got a ms1, extracode 24s9 and a tech-age WB controler. I have a supercharger in my car. I have a bost pressure of 1,3 bars. With this value of bost pressure, what kind of values I should use in the AFR table, to make sure it doesnt detonate? Thanks for your time.8)
Top
Bernard Fife
Super Squirter
Posts: 1009
Joined: Mon Feb 16, 2004 3:15 pm

Post by Bernard Fife »

I have a bost pressure of 1,3 bars. With this value of bost pressure, what kind of values I should use in the AFR table, to make sure it doesnt detonate?
Speedbuster,

That depends on a lot more than your boost, like the compression ratio, the combustion chamber characteristics, the efficiency of the turbo & intercooler, etc., etc., etc.

Lance.
Top
dumetre
MegaSquirt Newbie
Posts: 3
Joined: Tue Nov 30, 2004 11:29 am
Location: Michigan

.

Post by dumetre »

Does your AFR table display AFR or volts? Mine displays volts and I have been searching for a while trying to figure out how to change it. I am starting to think I need a newer code version since I have megatune 2.55.
Top
Post Reply

Return to “Tuning Fuel and Air”