hi,
i am trying to figure out why i don't have 12v from my mg11 v 3.0 board.
to my fuel pump relay.....
i have 13v available.
it is only putting out 5 volts to fuel relay relay. and they appear weak...
not enough to turn fuel pump on.
fuel pump led is on, ing's works
Please any ideas?
every thing else appears ok
new start up ms11 v 3.0 -fuel pump voltage only 5 v to pump?
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
The board is set up to switch the GROUND to the relay coil ,
with the other side of the relay coil connected to switched power
that is also hot while cranking .
Look here :
http://www.megasquirt.info/ms2/v3ext_wiring.gif
and here :
http://www.megasquirt.info/ms2/V3assemble.htm
...................Jim
with the other side of the relay coil connected to switched power
that is also hot while cranking .
Look here :
http://www.megasquirt.info/ms2/v3ext_wiring.gif
and here :
http://www.megasquirt.info/ms2/V3assemble.htm
...................Jim