lpg injectors HEELP

ranchero · Post by **ranchero** » Fri Apr 28, 2006 6:52 am

I just found out that these injectors are 6VOLT, is it possible to drive them with Megasquirt??
Or do i need some kind of voltreducer.
This is for the moment a big BUMMER.....
Ho can i determen the amperage of thes injectors, just hooking 6 volt to them with a amp meter in between?

Thanks for anny sugestions

Frank from belgium

mitsuko · Post by **mitsuko** » Fri Apr 28, 2006 6:59 am

Use an adjustable power supply and meaasure at what current they open .
Add a safety margin of 25% and use that as a hold current .

Peak current is usually 4 times higher .

You can still drive them with ms , but you'll need the pwm function .

Pat
MS dealer for bnlx

ranchero · Post by **ranchero** » Fri Apr 28, 2006 8:30 am

hey Pat, thanks for the reply, i over reacted a little to much.
I spoke a electrotechnic and he suggested a 4 Ohm 25 watt resistor to be on the save side to reduce the voltage and using pwm.
Im conserned on the spike of 12 volts these things can get trou MS so i gonna go for the resistors.

Frank

mitsuko · Post by **mitsuko** » Fri Apr 28, 2006 11:06 am

Are you sure the injectors are 6 volt .

A friend of mine is running bi-gas injectors and he's driving them with a std megasquirt without pwm .

Pat

ranchero · Post by **ranchero** » Sat Apr 29, 2006 12:23 pm

yes im pretty sure of it. Found it on lpg injection sites with some info on them an they speak of 6 volt injectors.