I have my LC-1 Wide band o2 sensor almost installed. It should be finished tomorrow.
I have run autotune with a narrow band sensor, so I know a little bit about how it works. Inderstand changing the .ini file for boost/vacuum and RPMs, but how do I adjust for the desired air fuel ratio I want? I have megatune 2.25 and MSnS 024s. Do I just change the EGO switch point voltage under EGO control to what ever ratio I want autotune to tune to? Also the AFR targest for VE table button is greyed out on my megatune. How can I use this?
Thanks
Karl
Autotune question
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.