CAN msg's

This forum is for discussion of MicroSquirt (TM) from Bowling and Grippo. The MicroSquirt information site is at www.usEasyDocs.com
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
SeanS
MegaSquirt Newbie
Posts: 6
Joined: Wed May 19, 2004 6:26 pm
Location: Marysville, WA
Contact:
Contact SeanS

CAN msg's

Post by SeanS »

I was initially looking for some docs on msg structures and couldn't find anything so I decided to browse the code directly. I noticed that we haven't done anything w/CAN yet ? I see a small section ifdef'd for test msgs though.

I was going to start work on a small datalogger and some other modules to hang off the bus. Am I not reading the code correctly ?
Top
grippo
MegaSquirt Guru
Posts: 921
Joined: Mon Feb 16, 2004 6:55 pm

Post by grippo »

You are correct. The code was tested with two processors talking to each other and that was it. The GPIO board will use the CAN interface, but the software for this isn't ready yet.
Top
SeanS
MegaSquirt Newbie
Posts: 6
Joined: Wed May 19, 2004 6:26 pm
Location: Marysville, WA
Contact:
Contact SeanS

Post by SeanS »

When the time comes, I wouldn't mind writing up any documentation or provide some independant testing help. Just let me know.
Top
Post Reply

Return to “MicroSquirt General Information”