plumbing fuel rails

For discussing injector selection, manifold modifications, throttle bodies, fuel supply system design and construction, and FIdle valves and IACs.
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
Fredde71
MegaSquirt Newbie
Posts: 3
Joined: Sat Feb 25, 2006 11:22 am
Contact:
Contact Fredde71

plumbing fuel rails

Post by Fredde71 »

I have a set of dash 6 (0.500" bore) fuel rails. What kind of adapters can I use to connect the feed and return lines to the fuel rails? AN to pipe thread or what?

Thanks
Top
fscott
Helpful Squirter
Posts: 72
Joined: Wed May 25, 2005 6:35 pm
Location: Bastrop, TX
Contact:
Contact fscott

Post by fscott »

I take it that the feed and return lines are of a type that cannot be directly connected to an AN hose end. If you can do that, it's the best option.

AN to pipe thread adaptors are very common, and from there you can go from pipe thread to hose barbs.

Fred
Top
Post Reply

Return to “Injectors, Fuel & Air Supply”