Yamaha R6 Injector/fuel pressure regulator

For discussing injector selection, manifold modifications, throttle bodies, fuel supply system design and construction, and FIdle valves and IACs.
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
Duffy
MegaSquirt Newbie
Posts: 1
Joined: Fri May 12, 2006 6:16 am

Yamaha R6 Injector/fuel pressure regulator

Post by Duffy »

Hi,

I'm using a set of R6 inejction TB's on a Focus ST170 manifold to fuel a 2.0 normally aspirated Zetec.

Does anybody know if the bike FPR will deliver sufficient pressure (I don't know what the bike fuel rail was pressurised to but I'm guessing it's lower than Ford would have set it to)

I'm using a bosch external fuel pump from a Ford Sierra (Circa 70 to 90 PSI)

Thanks! :)
Top
Post Reply

Return to “Injectors, Fuel & Air Supply”