ebit7??

billywillicker · Post by **billywillicker** » Wed May 31, 2006 6:24 pm

I may be stupid but what is this??? I have noticed my car runs good when it says y and shitty when it says n. thx for any reply

Jason

LT401Vette · Post by **LT401Vette** » Thu Jun 01, 2006 5:37 am

Unlike the 1st 6 bits that have a consistent definition, bits 7 and 8 are dependent on what firmware you are running. The leading meaning for bit 7 is map Acceleration.

What firmware are you running?

billywillicker · Post by **billywillicker** » Thu Jun 01, 2006 7:25 pm

i am running 024s9 code. I am having a really hard time getting this thing running good. my setup is a v1.01 board with msns-e 024 code running with a 8 pin hei setup. my spark control side of things is good, I just cant get the fuel in any kind of order. this is probably due to the fact that I really dont know what size injectors I am running in it. I think they are around 42lb injectors. I also have a narrow band o2 sensor. I am attaching my msq and a datalog. I have fixed the tach and dist, just notes to myself.

LT401Vette · Post by **LT401Vette** » Fri Jun 02, 2006 5:48 am

It seems like there is quite a bit of O2 reading 0 in there.

I'll move this post to the tuning section, you will probably get better response there.