My motorcycle revs to 17,500rpm
it's a four cylider engine, and it makes peak torque of 13lbt/ft at 13500, and peak horsepower of 38.4 hp at 17000 rpm (figures taken from dyno sheet)
These values are outside those permissable in the autogenerate table calcylautors i've found. Could anyone assist me in offering another way to generate a VE table starting point, or point me to the equations these calculators use so I can make my own calculator in MATlab?
Some assistance in developing a VE table for high revs
Forum rules
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
Bernard Fife
- Super Squirter
- Posts: 1009
- Joined: Mon Feb 16, 2004 3:15 pm
Fry,
See this: http://www.megamanual.com/ms2/VE12x12.htm and view the source file to see all the javascript that makes it happen (you can also edit the javascript and save it on your PC to disable the limits, then open it with your browser). The limits are reasonably well documented in a section called 'function check_errors'.
Lance.
See this: http://www.megamanual.com/ms2/VE12x12.htm and view the source file to see all the javascript that makes it happen (you can also edit the javascript and save it on your PC to disable the limits, then open it with your browser). The limits are reasonably well documented in a section called 'function check_errors'.
Lance.