Auto tune

QuarterHorse · Post by **QuarterHorse** » Sat Jun 17, 2006 9:29 am

I know there is a thread on the auto tune, but I can't find it on my MS software. I go to tuning, then to VE tables, and it's not there, HELP! I got the truck going just have no idea on where to begin to tune it and would like a rough starting area to go with.

Thanks,
Dustin

Bernard Fife · Post by **Bernard Fife** » Sat Jun 17, 2006 9:43 am

Dustin,

Check this: http://www.megamanual.com/megatune.htm#autotune

Lance.

QuarterHorse · Post by **QuarterHorse** » Sat Jun 17, 2006 10:03 am

Right, I do not have the "tools" option to select auto tune after I go into the VE tables. Not sure what the deal is.

Bernard Fife · Post by **Bernard Fife** » Sat Jun 17, 2006 10:04 am

QuarterHorse,

What processor and code do you have? What version of MegaTune?

Lance.

QuarterHorse · Post by **QuarterHorse** » Sat Jun 17, 2006 10:13 am

Not sure on either, I know the Megatune I put on my PC in the house has it, guess I must have to download another version and the laptop and start over again. *sigh*

QuarterHorse · Post by **QuarterHorse** » Thu Jun 22, 2006 7:03 pm

So I have a differen't version of Megatune on the laptop. Now, for whatever reason my duty cycle is reading at like 3,333,000.00 or some off the wall chart. I go to use Auto-tune and it tells me it's off the chart or somthing similar. I don't get this!

QuarterHorse · Post by **QuarterHorse** » Fri Jun 23, 2006 2:38 pm

Anybody have any insight in this?