Quickie novice starter AFR target tables.. How's this look?

For discussing MicroSquirt (TM) configuration and tuning of fuel parameters (including idle valves, etc.).
Forum rules
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
defiance
MegaSquirt Newbie
Posts: 18
Joined: Thu Aug 12, 2004 6:48 pm
Location: Little Rock, AR
Contact:
Contact defiance

Quickie novice starter AFR target tables.. How's this look?

Post by defiance »

Ok - I've been reading and reading, and since I'm finally starting to really look at the wideband o2 on my car, I generated a 'real' target afr table (instead of just 14.7's everywhere :P) Can anyone give me feedback on how this looks overall?
The engine is a mostly stock (internally) 70's era dodge 440. I don't have a dyno on it, but I'm thinking peak power will be in the 5,500 RPM range, and peak torque just below 3,000 RPM. Just guessing, but I think that should be pretty close.

Is there anything obvious I need to rethink on this? I know I'll need to tweak as I start driving it, but I just want to make sure to avoid 'starting' mistakes...
The years-long project: http://www.msefi.com/viewtopic.php?t=3043

Other info (stereo, interior, etc):
http://www.sounddomain.com/ride/2324498
Top
Post Reply

Return to “Tuning Fuel and Air”