High VE value low in the map after using VexMe, is this OK?

For discussing MicroSquirt (TM) configuration and tuning of fuel parameters (including idle valves, etc.).
Forum rules
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
steve r
MegaSquirt Newbie
Posts: 8
Joined: Fri Oct 14, 2005 9:14 am
Location: Maidenhead England

High VE value low in the map after using VexMe, is this OK?

Post by steve r »

Hi,

After using VexMe about 7-8 times to refine my map i have a very high value low down at 30kPa, 1000 rpm as shown below:

Image
(ignore the zero @ 20/500 its not actually that value in the MS)

This seems strangely high to me for such a low area in the map, is it correct/ok or should i drop the value down to a similar number to those surrounding it?

cheers

steve

(MS1 V2.2, MSnSE 24s, LC-1, MT release.)
Top
LT401Vette
Helpful Squirter
Posts: 75
Joined: Sat Jul 16, 2005 7:07 am
Location: Charlotte, NC
Contact:
Contact LT401Vette

Post by LT401Vette »

Post a log file and we can take a look. Ods are there is something occuring to make it appear lean to VexMe, but you don't really want to set that cell at 87.
Phil Tobin
EFI Analytics
http://www.efiAnalytics.com/
Top
steve r
MegaSquirt Newbie
Posts: 8
Joined: Fri Oct 14, 2005 9:14 am
Location: Maidenhead England

Post by steve r »

Here are a few recent log's

steve
Top
Post Reply

Return to “Tuning Fuel and Air”