AFR Tables in Volts

Forum for discussing Tuner StudioMS tuning & datalogging software.
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Post Reply
LT401Vette
Helpful Squirter
Posts: 75
Joined: Sat Jul 16, 2005 7:07 am
Location: Charlotte, NC
Contact:
Contact LT401Vette

AFR Tables in Volts

Post by LT401Vette »

Just wondering what the cercumstances are where the ARF table is saved to volts in the MSQ? I thought this was used back a while, but no longer. Or is it based on what WBO2 sensor you are using?

Thanks,
Phil Tobin
EFI Analytics
http://www.efiAnalytics.com/
Top
boost junkie
Helpful Squirter
Posts: 62
Joined: Tue May 11, 2004 7:58 am
Location: dallas texas usa

Post by boost junkie »

It depends on the WB sensor. You can look at the codebase INI file you are using (ms1, ms2, msns-e, etc) for the definition.
-shawn
msns-e controled turbo neon
sample msq's!
Top
Post Reply

Return to “Tuning Software”