Old US DIY-WB O2 settings?

PSIG · Post by **PSIG** » Mon Jul 31, 2006 4:47 pm

I found a misplaced DIY-WB kit from a few years ago for the L1H1 sensor. This is the old USA version. Once I get it built which O2 should I select in MT2.25 to get a good match? I want to try it in the current project with an MS1/029s/v3/mt2.25.

Don't ya just love re-finding stuff? Now if I could find that $100 bill I stashed...

TIA,
David

cosmo1stgen · Post by **cosmo1stgen** » Sat Aug 05, 2006 10:10 am

I use to have the old one v 1.5. From what I remember when I had mine the voltage output was non linear from 0-4 volts. I dont think megatune supports that. If the diy wideband website is still up they use to have a graph that ploted what voltage represented what afr. You may be able to program that plot into megatune custom ini.

PSIG · Post by **PSIG** » Sat Aug 05, 2006 1:55 pm

Thanks for the reply! I realized that the documentation in both the MegaManual and the MegaTune pages refers to the US version I have. I had assumed (doh!) that it referred to the later Australian version. All set!

David