Bench test
Moderators: grippo2, Bruce Bowling, grippo
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
ca434sbc4
- MegaSquirt Newbie
- Posts: 27
- Joined: Sun May 02, 2004 7:39 am
- Location: Calgary Alberta Canada
Bench test
Some progress today, had comm issues - now resolved - intermittent molded cable..
-
ca434sbc4
- MegaSquirt Newbie
- Posts: 27
- Joined: Sun May 02, 2004 7:39 am
- Location: Calgary Alberta Canada
Re: Bench test
Quick update, the unit is configured and ready to wire into the vehicle. I'll start this this week.
Re: Bench test
great.... can you share a few details about your setup? motor, ignition, trigger system, etc... for some reason, i'm thinking you might be running a 434sbc.
did you convert an existing msq, or start from scratch?
did you convert an existing msq, or start from scratch?
-
ca434sbc4
- MegaSquirt Newbie
- Posts: 27
- Joined: Sun May 02, 2004 7:39 am
- Location: Calgary Alberta Canada
Re: Bench test
Engine is a vortec 4200 DOHC 4 valve/cylinder inline 6 out of a trailblazer - the engine that is currently installed is an 2002 with stock internals. Last fall I bolted the turbo up to it. A good built engine is waiting to go in. This is about 3 weeks away.