Yes, I could make one with a hall sensor inside my own threaded tubing...but time is not something I have much of, so I figure I should just buy one!
Does anyone know of any suppliers with a sensor that is this size and will work well in a hot engine case (130C)? I have done some googling, but have not been able to find much!
Thanks and Cheers!
Aaron
M14x1.5 Hall Sensor?
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.