I use the table for my cranking pulse. My cranking pulse at 70 degree celsius is 1.8 ms on the table but my cranking pulse in megatune show around 3.6 ms. I use the v2.89 code. Someone can explain this cranking pulse.
My project is a snowmobile yamaha apex 2007.
Microsquirt V2
Embedded code 2.89
cranking pulse widht
Forum rules
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
cranking pulse widht
- Attachments
-
- avant diner.msl
- datalog
- (104.03 KiB) Downloaded 70 times
-
- samedi.msq
- msq file
- (25.03 KiB) Downloaded 71 times
Re: cranking pulse widht
To the cranking pulsewidth the code adds pulsewidth open time (time before fuel actually flows) + barometric correction + air temp correction + battery voltage correction.
Re: cranking pulse widht
Thank you for the explanation. I'm going to change my crankpulse table.