Hi,
We recently purchased a Microsquirt V3 to run the single cylinder engine of our FSAE car.
It says in the manual for V2 that you can drive a coil directly from the Microsquirt with no ignitor but there is no mention of V3. Is this possible with a V3 or was the feature removed for some reason? If so why?
Thanks.
V3 Driving coils.
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
Bernard Fife
- Super Squirter
- Posts: 1009
- Joined: Mon Feb 16, 2004 3:15 pm
Re: V3 Driving coils.
iainr2012,
For V3 MicroSquirt, you should start reading here: http://www.useasydocs.com/quickstart.htm
You might then want to surf to this: http://www.useasydocs.com/details/wire.htm#ignition
Lance.
For V3 MicroSquirt, you should start reading here: http://www.useasydocs.com/quickstart.htm
You might then want to surf to this: http://www.useasydocs.com/details/wire.htm#ignition
Lance.