I get most of my trigger wheels done by laser cutting, which with a good sensor is an adequate machined surface. Anything CNC'd is more expensive.
36-N crank trigger wheel. on 180deg parallel twin.
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
24c
- Master Squirter
- Posts: 593
- Joined: Sat Feb 16, 2008 12:15 pm
- Location: Chorley, Lancashire UK
- Contact:
Re: 36-N crank trigger wheel. on 180deg parallel twin.
I'm in the UK, but send me the CAD file, and I'll see what I can do. Just depends on postage & duty etc though whether it would be economic for you, but $110 is a lot of "fat".
I get most of my trigger wheels done by laser cutting, which with a good sensor is an adequate machined surface. Anything CNC'd is more expensive.
I get most of my trigger wheels done by laser cutting, which with a good sensor is an adequate machined surface. Anything CNC'd is more expensive.
-
triangles95
- MegaSquirt Newbie
- Posts: 33
- Joined: Mon Dec 14, 2009 9:32 am
Re: 36-N crank trigger wheel. on 180deg parallel twin.
Thanks for the offer. I may take you up if I don't find anything more reasonable closer to home 