Hi All,
All the tutorial/youtube info I've seen tells me that when initially setting up TunerStudio and installing an LC-1 wideband hago, you choose 'LC-1 Wideband' from the drop down menu....
All I seem to get in the setup options (ver 2.0.8 ) is Lambda, Narrowband Sensor and Wideband.
Is it enough to just set it to Wideband? Or am I missing a setup stage later on?
Cheers
LC-1 Wideband
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
Matt Cramer
- Super Squirter
- Posts: 910
- Joined: Sat Jul 03, 2004 11:35 am
Re: LC-1 Wideband
There are a couple menus where you set this up; the section you're referring to is for the menu under Tools -> Calibrate AFR Table.
Matt Cramer at DIY Autotune
