Hi
It would appear I have no ignition advance, stuck at 10deg double checked everything, I have no way of checking the pulse at PIP, would it be wrong to assume that the EDIS module is not generating a PIP? or can the Microsquirt V3 not generate the SAW back to the EDIS? on the laptop all is OK I can see the advance table I can also alter it, but no advance where it matters. I guess what I'm asking is: from the forums experience are the EDIS and Microsquirt modules guilty of this fault?
Alan
EDIS Help
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Re: EDIS Help
The MicroSquirt is capable of controlling an EDIS module; take a look at the manual, check your wiring and settings.
Re: EDIS Help
Hi
Double checked and all OK, have tested the SAW from ECU and have 2.5 volts @ idle and 4.4 volts @ 3000rmp tested @ EDIS module, so I'm assuming the EDIS is not seeing the voltage generated from MS, all settings are per MS manual for controlling an EDIS system
Alan
Double checked and all OK, have tested the SAW from ECU and have 2.5 volts @ idle and 4.4 volts @ 3000rmp tested @ EDIS module, so I'm assuming the EDIS is not seeing the voltage generated from MS, all settings are per MS manual for controlling an EDIS system
Alan