Hello,
We currently running this MicroSquirt:
http://www.diyautotune.com/catalog/micr ... p-519.html
With the latest MSextra2 firmware.
We hooked up an oscilliscope to the VR line and we are reading the right values but tuner studio isnt picking up the RPM (we tried adding a 1k/100k ohm resistor but that did not help)
I will update this thread with an image of the signal and TS settings; we have 18 teeth with one missing(in TS we set up everything we believe is right).
Has anyone had any alternate means of fixing this? Any input would be appreciated
MicroSquirt RPM readings
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
24c
- Master Squirter
- Posts: 593
- Joined: Sat Feb 16, 2008 12:15 pm
- Location: Chorley, Lancashire UK
- Contact:
Re: MicroSquirt RPM readings
HiWith the latest MSextra2 firmware.
You are asking in the wrong forum...try this one
Mike
PS You need to add msq or datalog when you do!
