I have recently installed and setup an MS v3 with the latest firmware. (3.84?)
I tried triggering off the coil neg but it didn't read the signal.
I have bought a 36-1 wheel and it would be much simpler to set up on the cam pulley instead of the crank.
Is this possible?
I understand this is running at half speed of the crank.
This is for a fuel only install and spark is not required.
Triggering off cam
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Re: Triggering off cam
One thing I was thinking was to take off another tooth, 180 degrees from the other.
Then I could say it was an 18 tooth wheel with skip teeth set to 9.
This should give me a signal every time it was at TDC and RPM's etc would read correctly.
Am I right along this train of thought?
Then I could say it was an 18 tooth wheel with skip teeth set to 9.
This should give me a signal every time it was at TDC and RPM's etc would read correctly.
Am I right along this train of thought?
-
24c
- Master Squirter
- Posts: 593
- Joined: Sat Feb 16, 2008 12:15 pm
- Location: Chorley, Lancashire UK
- Contact:
Re: Triggering off cam
Hi ozzie
If you go to the manual page then you will see option 4 under the Dual Spark Set Up, which is a missing tooth (M-N) for a cam only set up, as in NO crank trigger.
Enjoy
Mike
PS I've used it!
If you go to the manual page then you will see option 4 under the Dual Spark Set Up, which is a missing tooth (M-N) for a cam only set up, as in NO crank trigger.
Enjoy
Mike
PS I've used it!