Good morning Matt,
I discovered the problem... On ignition settings -> Ignition Options / Wheel Decoder -> spark output -> Going Low. It was going high. In manual it's wrote that for microsquirt is typically going high. I'm reading manual to discovery why I have leave in Going Low....
Problem with analog signals
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
Adriano Custódio
- MegaSquirt Newbie
- Posts: 7
- Joined: Sun May 31, 2015 2:38 pm