Hey guys,
New to the forum but my project is a 1979 cb750f Efi conversion with a microsquirt and a set of gsxr 750 throttle bodies,
I have mounted the computer and the throttle bodies are all set to go other than the fuel rail.
So i was wondering how do I set up the CDI ignition to put out a tach signal?
I know it has been done but i would need to know what resistors and how to wire them up.
Thanks in advance for any input
Calvin
Elusive tach signal on cb750
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
calvincb750
- MegaSquirt Newbie
- Posts: 3
- Joined: Wed Jun 24, 2015 5:50 pm