Hello all, im new to megasquirt and have recently purchased a pre-assembled v2.2 that I intend to fit to my fathers 4.2 classic range rover. One kind chap gave me the settings he used on his 4.2 rover however I cannot burn these values to my ecu. Do I need to connect it to a stimulator to burn values to the ecu's memory? I connected a 12v power supply to the ecu, opened up megatune version 2.25b698beta, and entered the realime display - the time runs up to 255 and then starts from zero again. When I Click on the communications test I get "success".
Despite all this when I click "burn to controller" I get the message "could not connect with controller".
Sometimes when I try to open megatune with the ecu connected I get a message stating:
"Controller code version does not match signature in Megasquirt-I-ini. (see audit log for where the above file was found.)
Expected "0x14"
Recieved "" (from controller)
Table corruption may occur
Terminate megatune now?
Sorry if this is a bit vague as I say im new to this.
Thanks and regards to all
Nathan
