Potted uS IAT CLT Sensors

BentRods · Post by **BentRods** » Tue Jan 24, 2006 4:30 pm

If uS is potted to make it water proof, so how would one go about changing the resistors etc on the PCB to cater for other Temp sensors that may be used, not everyone is using GM parts.
or has this been addressed ?

If its an option I'll order mine without the potting mix all over the PCB ... perhaps sealant on the end plates would be good enough.

BentRods

Bernard Fife · Post by **Bernard Fife** » Tue Jan 24, 2006 4:35 pm

BentRods,

In MS-II/MicroSquirt you don't have to change the bias resistors, you can reset the temperature calibration curves in MegaTune under 'Tools/Calibrate Thermistor Tables'.

Lance.

sidy · Post by **sidy** » Tue Jan 24, 2006 5:25 pm

I second that!

I am happy to seal the case myself just in case I pickup a bike with OEM efi h/ware and non-compatible sensors.

Sid
Posted by email.

BentRods · Post by **BentRods** » Wed Jan 25, 2006 6:48 am

Thanks Lance
Where can I read all of these juicy details you speak of ?

.. or is this the kinda stuff the list Mum's & Guru's talk about while injecting a few stubbies (Beers) around the MS BBQ ...

BentRods

78Spit1500Fed · Post by **78Spit1500Fed** » Wed Jan 25, 2006 7:13 am

BentRods wrote:...is this the kinda stuff the list Mum's & Guru's talk about while injecting a few stubbies around the MS BBQ ...

Hey, we only speak english on this forum...

-Brian

AndrewPolly · Post by **AndrewPolly** » Thu Feb 02, 2006 7:05 pm

lol!