Thanks chaps, This is only possible due to Eric's excellent modular approach to Megatune.
I dont think it's worth spending and valuable dev time on hysteresis right now.
I'm going to get the hair-dryer out with the datalog running and measure/graph the response time of the thermistors.
Turbo Adiabatic Efficiency and Intercooler Efficiency Gauges
Forum rules
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
Forum rules
Read the manual to see if your question is answered there before posting. If you have questions about MS1/Extra or MS2/Extra or other non-B&G code configuration or tuning, please post them at http://www.msextra.com The full forum rules are here: Forum Rules, be sure to read them all regularly.
-
eliotmansfield
- Helpful Squirter
- Posts: 55
- Joined: Sat Apr 03, 2004 12:39 am
- Location: Milton Keynes - UK
- Contact:
-
efahl
- Site Admin
- Posts: 232
- Joined: Mon Feb 16, 2004 3:15 pm
- Location: San Clemente, California, USA
- Contact:
Yeah, exactly my thoughts, this has been on my list for years. When I had my big intercooler fabbed, I made them add a couple big pads on the tanks so I could put sensors there. Maybe Eliot's example will get me off my butt and into the garage.FoundSoul wrote:I was wanting to do exactly this when I finally get my turbo project revived again.
Eric