Posted: Tue Apr 11, 2006 2:13 pm
If I end up having trouble with them so closely mounted, I'll be sure to let everyone know.
-Dave
-Dave
MicroSquirt.com read only forum (Jan.15,2018)
Read only forum for MicroSquirt(R) from Bowling and Grippo
http://www.microsquirt.com/
MSII vs. MSD for ignition
Page 2 of 2
Posted: Tue Apr 11, 2006 6:38 pm
I was thinking about placing the MSD just below the MS-II - Steve
Posted: Tue Apr 11, 2006 7:34 pm
That setup in the photo looks good - I would try and keep a small distance between the msd and ms cables. For example, I have seen a car with a conventional reluctor dissy misfire and carry on because the wires from the reluctor in the dissy were routed next to the ignition coil leads - the ignition module was getting false triggers from the noise. The problem went away after the wiring was moved. (It happened on 2 cars - 1 was an old carby RX-7 and the other an efi-converted-to-lpg range rover V8.)