Page 1 of 1
Potted uS IAT CLT Sensors
Posted: Tue Jan 24, 2006 4:30 pm
by BentRods
If uS is potted to make it water proof, so how would one go about changing the resistors etc on the PCB to cater for other Temp sensors that may be used, not everyone is using GM parts.
or has this been addressed ?
If its an option I'll order mine without the potting mix all over the PCB ... perhaps sealant on the end plates would be good enough.
BentRods
Posted: Tue Jan 24, 2006 4:35 pm
by Bernard Fife
BentRods,
In MS-II/MicroSquirt you don't have to change the bias resistors, you can reset the temperature calibration curves in MegaTune under 'Tools/Calibrate Thermistor Tables'.
Lance.
Potted uS IAT CLT Sensors
Posted: Tue Jan 24, 2006 5:25 pm
by sidy
I second that!
I am happy to seal the case myself just in case I pickup a bike with OEM efi h/ware and non-compatible sensors.
Sid
Posted by email.
Posted: Wed Jan 25, 2006 6:48 am
by BentRods
Thanks Lance
Where can I read all of these juicy details you speak of ?
.. or is this the kinda stuff the list Mum's & Guru's talk about while injecting a few stubbies (Beers) around the MS BBQ ...
BentRods
Posted: Wed Jan 25, 2006 7:13 am
by 78Spit1500Fed
BentRods wrote:...is this the kinda stuff the list Mum's & Guru's talk about while injecting a few stubbies around the MS BBQ ...
Hey, we only speak english on this forum...
-Brian
Posted: Thu Feb 02, 2006 7:05 pm
by AndrewPolly
