Wont Start, previously working setup...
Posted: Sat Jan 28, 2006 2:48 pm
Ok, I have a 4 cyl bmw m10 engine, it was previously running with ITB throttle units, as well as with the stock manifold.
I turbo'd the car during the x-mas holiday, and used 42lb/hr "green top" injectors. since then the car wouldnt start.
I started with a clean install of 029d and put in pretty much all of the values, except for the "mS" units as I'm aware that they change.
It seems the car starts, but then when in running mode, the PW goes to zero. I plan to datalog it tomorrow.
If someone could review my MSQ, it would be great
I'm running EDIS on led17.
Thanks.
I turbo'd the car during the x-mas holiday, and used 42lb/hr "green top" injectors. since then the car wouldnt start.
I started with a clean install of 029d and put in pretty much all of the values, except for the "mS" units as I'm aware that they change.
It seems the car starts, but then when in running mode, the PW goes to zero. I plan to datalog it tomorrow.
If someone could review my MSQ, it would be great
I'm running EDIS on led17.
Thanks.