MicroSquirt.com read only forum (Jan.15,2018)

Hi there,
I got a strange situation with the duty cicle. I have a extracode 025n9 firmware installed (msI system), it is defined to work with the alternated injection with two squirts.
For reasons that i don't know, the duty cycle 1 is working the half of the duty cycle 2 for the same pulse. to change this, i tried to change the injection to the simultaneous one; in this case it was goind well, but the same problem ocurred again.
I got no idea how to solve this.

Speedbuster,

That's normal, read this:

http://www.msefi.com/viewtopic.php?t=11825

Lance.

Lance wrote:Speedbuster,

That's normal, read this:

http://www.msefi.com/viewtopic.php?t=11825

Lance.

Is the answer somewhere else? This link gives me:

Warning: main(./m2f/m2f_phpbb204.php): failed to open stream: No such file or directory in /home/megasq2/public_html/common.php on line 199

--Dan

I think ( if I remember correctly ) what you are seeing is normal, the DC2 applies to the second fuel table ( when dual table is enabled ). If you are only running in single table mode, DC1 applies to both injectors.