Page 1 of 1
CAN or no CAN ?
Posted: Tue Feb 28, 2006 8:34 am
by 69 1/2 Six Pack Bee
I am going to load the s19 files (thanx Lance for the help) into my MS-II daughtercard and need to know the difference between the std. MS-II and that with the CAN option. I am using my existing MS-I, V2.2 with the flyback mod and am going with the IAC and 8-pin HEI and keeping the GM TBI but everything will remain unchanged. I am running a manual tranny so I am not looking for transmission control. I may (this is a BIG "may") step up to direct sequential injection in the future so this begs the question; which version?
Thanx again,
Bud
Posted: Tue Feb 28, 2006 8:58 am
by ChevelleFan
Whether you use the CAN code or not depends on your MS-II daughtercard.
If the silicon is green, you have a non-CAN version -- use MS-II code version 1.x. If the silicon is blue, you have a CAN version and use MS-II code version 2.x.
-Dave
Posted: Tue Feb 28, 2006 2:23 pm
by 69 1/2 Six Pack Bee
I don't have it in front of me right now but I know the board is a blue-green color. I just got it from Glen.
Thanx,
Bud
Posted: Tue Feb 28, 2006 2:26 pm
by Bernard Fife
Bud,
You can also look to see if the CAN chip is there:
The CAN chip has 8 legs. Beta MS-IIs had a three legged transistor in this location, production V1 MS-IIs had a blank spot.
Lance.
Posted: Tue Feb 28, 2006 11:38 pm
by 69 1/2 Six Pack Bee
I got a CAN chip!
Thanx for the explaination, Lance!